Type |
Message |
Meaning and the appropriate action |
A |
????? |
Program is damaged by creating non-existing function in the code. Re-enter your program. |
CIRCUIT ERR |
Number of logical blocks doesn't match the instructions of logical blocks. Check the program. |
OPERAND ERR |
Entered constant is not in allowed range. Change the constant so that it fits in the proper range. |
NO END INSTR |
Program is missing the instruction END(01). Add END(01) to the last address of the program. |
LOCN ERR |
Instruction is in the wrong place of the program. Check what the instruction demands and correct the mistake. |
JME UNDEFD |
Instruction JME(04) is missing the instruction JMP(05). Correct the number of jump and add the correct JME(04) instruction. |
DUPL |
Same number of jump or subroutine is used twice in the program. Correct the program so that each number is used only once. |
SBN UNDEFD |
Instruction SBS(091) is programmed for non-existing subroutine. Correct the number of subroutine or create the missing one. |
STEP ERR |
STEP(08) with the number of section and STEP(08) without the number of section are used illegally. Check the demands of instruction STEP(08) and correct the mistake. |
B |
IL-ILC-ERR |
IL(02) and ILC(03) are not used in pair. Check if every instruction IL(02) has its corresponding ILC(03). This message will also appear in case that multiple IL(02) instructions were used with single ILC(03) instruction. Check if that's exactly what you wanted... |
JMP=JME ERR |
JMP(04) and JME(05) are not used in pair. Before proceeding, check if the program is written exactly the way you wanted. |
SEN-RET ERR |
If the address of instruction SBN(92) is displayed, there are two different subroutines with the same number. Change one of the numbers or delete one of the subroutines in question. If the address of instruction RET(93) is displayed, RET(93) wasn't used appropriately. Check the demands of this instruction and correct the mistake. |
C |
COIL DUPL |
Same bit is controlled by more than one instruction (for example, OUT, OUT NOT, DIFU(13), KEEP(11), SFT(10)...). Although certain instructions allow this, you should check the demands of specific instructions, make sure that the program is correct or rearrange the program so that each bit is controlled by single instruction. |
JMP UNDEFD |
JME(05) is used without JMP(04) with the same number of jump. Add the instruction JMP(04) with the same number or delete JME(05) that is not used. |
SBS UNDEFD |
There is a subroutine that is not called by SBS(91). Add subroutine call to an appropriate place in the program or delete the subroutine. |